Mitsubishi Heavy Industries SRK25ZJP-S Manuel d'utilisateur télécharger pdf (Page 17)

–16–

Turn off the power supply.

Remove the air filter

Maintenance

Cleaning the air filter Standard interval is once every two week

Do not use the following articles:

• Hot water (40°C or more)

It may deform or discolour the unit.

• Petrol, paint thinner, benzine or cleanser, etc.

They may deform or scratch the unit.

• Do not spill any liquid.

• Do not touch the aluminum fins on the heat

exchanger.

•

Stand firmly on a stepladder or other stable

object when removing the inlet panel and filter.

Cleaning

CAUTION

• Do not clean the filters with boiling water.

• Do not dry them over an open flame.

• Pull them out gently.

Cleaning the unit

• Wipe the unit with a soft, dry cloth, or use a vacuum cleaner.

• If the unit is very dirty, wipe it with a cloth soaked in warm water.

Before maintenance

Reinstall the air filter

• Hold firmly the filter at both sides as shown at right

and insert securely.

• Operating without putting back the air filters will

make the unit dusty, and may cause damage.

Cleaning the air inlet panel

• Removal, installation of air inlet panel.

• The panel can be washed with water. After washing

with water, wipe any moisture off the panel and dry

out of direct sunlight.

Wipe the unit with a soft,

dry cloth.

During the operational season

• Pull up the air inlet panel forward.

•

Lightly hold the knobs at both sides and lift a

little to remove the panel forward.

If the filter is very dirty, clean it with warm water (approx. 30°C),

and dry it thoroughly.

How to open, close the air inlet panel

Open

Place fingers at the recesses on both sides of the panel and pull up the panel

forward so that it will be open by about 60 degrees.

Removal

When removing the air inlet panel for internal cleaning or others, open the

panel by 80 degrees and then pull it forward.

Removal, installation of air inlet panel

Push both ends evenl

and

ress further li

htl

at the center.

There's a danger

of electric shock.

Installation

Secure the upper edge of the air inlet panel by lightly pushing it in, and then

close the

anel.

RKX012A316_EN_001-020 12/21/2009, 10:4116

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 201 202

Commentaires sur ces manuels

Pas de commentaire

Mitsubishi Heavy Industries SRK25ZJP-S Manuel d'utilisateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Climatiseurs à système divisé Mitsubishi Heavy Industries SRK25ZJP-S